Per-Service Session Thresholds

Per-service Session Thresholds

Threshold monitoring can be enabled for the per-service session counts described in the following table.

Value Description
LNS Services Enables the generation of alerts or alarms based on the number of sessions facilitated by any LNS service counted during the polling interval.

Saving Your Configuration

When you configure thresholds they are not permanent unless you save the changes. When you have completed configuring thresholds, save your configuration to flash memory, an external memory device, and/or a network location using the Exec mode command save configuration . For additional information on how to verify and save configuration files, refer to the System Administration Guide and the Command Line Interface Reference.

Per-LNS Service Thresholds

Per-LNS service thresholds generate alerts or alarms based on the total number of sessions facilitated by any LNS service configured on the system during the specified polling interval.

Alerts or alarms are triggered for sessions per-LNS service based on the following rules:
  • Enter condition: Actual total number of sessions > or = High Threshold

  • Clear condition: Actual total number of sessions < Low Threshold

If a trigger condition occurs within the polling interval, the alert or alarm will not be generated until the end of the polling interval.

Configuring Per-LNS Service Thresholds

Use the following example to configure the per-LNS service thresholds:

configure 
 threshold per-service-lns-sessions <high_thresh> [ clear <low_thresh> ] 
 threshold poll per-service-lns-sessions interval <time> 
 threshold monitoring subscriber 
      end