Install Wizard Process
-
Follow the prompts in the Install Wizard to specify the following:
-
IPv4, IPv6, or both.
-
LAN 1 IPv4 subnet mask of the Cisco Expressway (if you select IPv4).
-
IP address of the Expressway default gateway.
-
Password for root user account.
-
Password for admin user account.
-
Whether to enable the Expressway web UI (recommended).
If you plan to deploy the appliance as an Expressway-E then you must enable the web UI. It's not possible to configure the appliance as an Expressway-E through the CLI.
-
Whether to allow SSH access to the Cisco Expressway CLI.
-
Timezone. The default is UTC. You can search and replace with your desired zone in the wizard. Or you can change it later through the
page in the web user interface.
-
-
Wait for the wizard to finish and the Installation wizard complete message to appear.
-
Press Enter to continue.
-
The system applies the specified settings and continues to boot.
-
After the boot completes, the Expressway is ready to use.
Note |
The system services restart after the wizard completes. This is expected behavior. |
You can now access the Expressway user interface using the IP address assigned to the LAN1 Ethernet port (see next section).