Guidelines and Limitations for IP SLAs UDP Jitter Operations for VoIP
-
This feature uses UDP traffic to generate approximate Voice over IP scores. It does not provide support for the Real-Time Transport Protocol (RTP).
-
The Calculated Planning Impairment Factor (ICPIF) and MOS values provided by this feature, while consistent within IP SLAs, are estimates only and are intended only for relative comparisons. The values may not match values that are determined using other methods.
-
Predictions of customer opinion (such as those listed for the E-Model transmission rating factor R and derived Mean Opinion Scores) that are determined by any method are intended only for transmission planning and analysis purposes and should not be interpreted as reflecting actual customer opinions.
Configuring CoPP for IP SLA Packets
When using IP SLA operations on a large scale, a specific CoPP configuration to allow the IP SLA packets to pass through might be needed. Since IP SLA uses user defined UDP ports, there is no way to allow all IP SLA packets to the control plane. However, you can specify each destination/source port that IP SLA can use.
For more information about the verified scalability of the number of IP SLA probes, see the Cisco Nexus 7000 Series NX-OS Verified Scalability Guide.
The following shows an example of a CoPP configuration that allows IP SLA packets to pass through. It assumes destination ports and source ports in the range of 6500-7000.
ip access-list copp-system-sla-allow
10 remark ### ALLOW SLA control packets from 1.1.1.0/24
20 permit udp 1.1.1.0/24 any eq 1967
30 remark ### ALLOW SLA data packets from 1.1.1.0/24 using ports 6500-7000
40 permit udp 1.1.1.0/24 any range 6500 7000
statistics per-entry
ip access-list copp-system-sla-deny
10 remark ### this is a catch-all to match any other traffic
20 permit ip any any
statistics per-entry
class-map type control-plane match-any copp-system-class-management-allow
match access-group name copp-system-sla-allow
class-map type control-plane match-any copp-system-class-management-deny
match access-group name copp-system-sla-deny
policy-map type control-plane copp-system-policy
class copp-system-class-management-allow
set cos 7
police cir 4500 kbps bc 250 ms conform transmit violate drop
class copp-system-class-management-deny
police cir 4500 kbps bc 250 ms conform drop violate drop
control-plane
service-policy input copp-system-policy