Cisco Nexus 7000 Series OTV Command Reference

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Book Contents

Find Matches in This Book

Results

Updated:: May 16, 2017

Chapter: T Commands

track-adjacency-nexthop

T Commands

track-adjacency-nexthop

track-adjacency-nexthop

To enable overlay route tracking, use the track-adjacency-nexthop command. To disable the setting, use the no form of this command.

track-adjacency-nexthop

no track-adjacency-nexthop

Syntax Description

This command has no arguments or keywords.

Command Default

Disabled

Command Modes

OTV router configuration mode.

Command History

Release	Modification
6.2(2)	This command was introduced.

Usage Guidelines

This command tracks only the site-adjacent edge device. The site-adjacent device must be reachable only by Interior Gateway Protocol (IGP) and not by any static routes or default routes.

This command requires a Transport Services license.

Examples

This example shows how to enable overlay route tracking:

switch(config)# otv-isis default
switch(config-router)# track-adjacency-nexthop

Related Commands

Command	Description
feature otv	Enables OTV on this device.

Was this Document Helpful?

Feedback

Contact Cisco

Open a Support Case
(Requires a Cisco Service Contract)