H Commands
This chapter describes the Cisco NX-OS IGMP snooping commands that begin with H.
hardware multicast snooping group-limit
To configure the number of groups learned through IGMP Snooping, use the hardware multicast snooping group-limit command.
hardware multicast snooping group-limit limit
Syntax Description
limit |
Number of groups learned through IGMP Snooping. The range is from 100 to 8000. |
Command Default
None
Command Modes
Any command mode
Command History
|
|
5.2(1)N1(1) |
This command was introduced. |
Usage Guidelines
Before setting a new group-limit, you must either clear the MAC address table or clear the groups already learned.
The unique OIFL (output interface list) combinations can only be 2000.
Use the vPC type-2 inconsistency to show the configuraitons on vPC peers.
A reload is not neccessary after configuring the group-limit.
This command does not require a license.
Examples
This example shows how to set the maximum number of groups to 500:
switch(config)#
hardware multicast snooping group-limit 500
Related Commands
|
|
show ip igmp snooping groups |
Displays information about the group membership for IGMP snooping. |
Usage Guidelines
This command does not require a license.
Examples
This example shows how to clear the explicit tracking information for VLAN 1:
switch#
clear ip igmp snooping explicit-tracking vlan 1
Related Commands
|
|
show ip igmp snooping explicit-tracking vlan |
Displays explicit host tracking information for IGMPv3. |