- About this Document
-
- About Cisco Enterprise NFVIS
- Installing Cisco Enterprise NFVIS Using the KVM Console
- Setting Up System Configuration
- Cisco Network Plug-n-Play Support
- Overview of VM Life Cycle Management
- VM Deployment Scenarios
- SPAN Session or Port Mirroring
- Configuring Packet Capture
- VM Image Packaging
- Upgrading Cisco Enterprise NFVIS
- Configuring vBranch High Availability
- Cisco ENCS Single WAN IP Deployment Scenarios
- Resetting to Factory Default
- NETCONF Event Notifications
- Syslog
- SNMP Support on NFVIS
- TACACS and RADIUS Support on NFVIS
- ENCS Switch Configuration
- Configuring Secondary IP Address and Source Interface
- Ports and Port Channels
- MSTP for ENCS 5400 8-Port Switch
- ENCS 5400 Switch LLDP
Resetting to Factory Default
Factory default reset is available on all NFVIS supported hardware platforms.
You can reset the host server to factory default with the following options:
-
Reset all—Deletes VMs and volumes, files including logs, images, and certificates. Erases all configuration. Connectivity will be lost, and the admin password will be changed to factory default password.
-
Reset all-except-images—Delete VMs and volumes, files including logs, user uploaded files and certificates. Erases all configuration except registered images. Connectivity will be lost, and the admin password will be changed to factory default password.
-
Reset all-except-images-connectivity—Deletes VMs and volumes, files including logs and certificates. Erases all configuration except images, network, and connectivity.
![]() Note |
Factory default reset must be used only for troubleshooting purpose. We recommend you contact Cisco Technical Support before performing factory default reset. This feature will reboot the system. Do not perform any operations until the system reboots successfully. |
To reset to factory default:
nfvis#factory-default-resetall|all-except-images|all-except-images-connectivity
![]() Note |
Enter Yes when you are prompted with the factory default warning message or no to cancel. |
Factory Default APIs and Commands
Factory Default APIs |
Factory Default Commands |
---|---|
|
|