Support for BITS is not currently available on the Cisco CRS. This information is provided as future reference only.
The line card chassis fan controller card contains the circuitry for the building integrated timing source (BITS) clocking.
BITS is centralized clocking architecture that provides a single common network clock for all SONET/SDH equipment in a point-of-presence
(POP) or central office.
The main component of the BITS architecture is a Stratum 1 clock signal that comes from a dedicated transport facility or
a GPS receiver. A BITS “box” in the central office or POP receives this reference clock signal and distributes it through
dedicated T1 (1.544 MHz) or E1 (2.048 MHz) facilities to all of the SONET/SDH equipment that requires network timing (digital
switches, DCSs, ADMs, routers, and so on). In this way, all of the equipment is synchronized to the same primary clock. The
BITS box also contains a Stratum 2 (or Stratum 3E) local clock to provide a holdover clock signal in case the primary network
clock signal is lost. If the input Stratum 1 clock fails, the holdover clock signal is used.
The BITS clock signals are analog alternate mark inversion (AMI) signals.
The fan controller card receives the BITS clock signal through an RJ-45 connector on its front panel. The BITS clock signal
is routed to synchronous equipment timing source (SETS) circuitry on the fan controller card. The SETS circuitry locks onto
the BITS reference timing signal and generates a 19-MHz clock signal, which it then distributes to each PLIM slot in the line
card chassis. This ensures that all PLIMs are synchronized to the same primary clock.
For redundant operation, each fan controller card receives two independent input BITS clock signals (EXT CLK 1 and EXT CLK
2). If one of the primary clock sources fails, the SETS circuitry reverts to the redundant input BITS reference timing signal.
If both input timing signals fail, the SETS circuitry enters a holdover mode and uses an internal Stratum 3 (12.8-MHz) clock
as the reference timing signal. This way, all of the PLIMs in the line card chassis receive an accurate timing signal.
Each BITS RJ-45 connector supports one input signal:
Pins 1 and 2 support one pair of RTIP and RRING signals.
Pins 4 and 5 are not used.
Each fan controller card has two RJ-45 BITS connectors. This means that a line card chassis can receive four BITS input clock
references (2 per fan controller card).