The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
The CRS Back-to-Back System supports several options for system management connections, and it provides connections for triggering external alarms and controlling optical cable clocking. A console port connection must be established before the system can be configured and become operational. The optional external alarm and network clocking features can be cabled at any time.
This chapter describes the following cabling options:
The initial configuration of an PRP takes place through the console port. Although PRPs have Ethernet ports, the Ethernet ports cannot be used until they are configured.
To connect to any of the console ports in the CRS Back-to-Back System, use a rollover cable with an RJ-45 connector on the end that connects to the CRS Back-to-Back System component. Typically, the other end of the rollover cable also uses an RJ-45 connector. The other end of the rollover cable may connect to a terminal, computer running terminal emulation software, or terminal server. Adapters are available to connect the RJ-45 connector on the rollover cable to a variety of serial ports. For more information on rollover cables and connectors, see the following web page:
For information on connecting to the console port on an PRP, see Cisco IOS XR Getting Started Guide .
Auxiliary ports are provided on the PRP card for remote connections through modems. PRP auxiliary ports can be used to configure the CRS Back-to-Back System.
The typical connection to the auxiliary ports uses a serial cable with RJ-45 connectors at each end. As with the rollover cable, adapters are available to connect the RJ-45 connector at the other end to a variety of serial port types. Cisco IOS XR Getting Started Guide provides illustrations that show how PRP auxiliary ports are connected through modems to a remote terminal.
Each PRP provides a Management Ethernet port that can be used to manage the PRP through an Ethernet network. This port can also be used to download software to PRPs in the CRS Back-to-Back System or transfer files to remote servers for analysis or backup storage.
The typical connection to the Management Ethernet port uses an Ethernet cable with RJ-45 connectors at each end. The other end of the cable typically connects to an Ethernet switch, hub, or router that provides connectivity between the CRS Back-to-Back System and networks from which system management is desired.
For information on connecting to the Management Ethernet port on an PRP, see Cisco IOS XR Getting Started Guide .
Each AC or DC power shelf in LCCs contains an alarm module that monitors the status of the power shelf and provides an external interface for system alarms. The same alarm module is used in all power shelves. For more information on alarm module connections, see Cisco CRS Carrier Routing System 16-Slot Line Card Chassis System Description .
When you have completed the cabling connections described in this chapter, document these connections and forward them to the people who will configure the system. For example, if you have cabled the console port to a terminal server so that people can access the console port from a network, they need the IP address of the terminal server and corresponding port number before they can use the console port.