vEdge Deployment Failures

In case of vEdge deployment failures, verify the following:

• Chassis ID provided is available in vManage and ensure it is not assigned to any other device.

• The values in the Virtual Router Device Specific Configuration page are accurate including the following information:

  • There must be no duplicate entry for the System-IP, site-id, or Host name which is already there in the vManage inventory.

  • Verify if the vBond IP is configured correctly, and verify that the vBond Controller is added to vManage.

  • To establish overlay path, vpn-0 configuration is important. Check if all configuration is complete in vpn-0.

  • Verify if the CA certificates pushed from vManage to vEdge are correct.

  • Verify if all the Certificates are in Valid state in vManage and sent to vBond Controllers.

  • The Device Status of the vBond controller must be In-Sync with the status in vManage.

  • Ensure that the WAN port group is created with the correct WAN VLAN.