This article is one in a series to assist in the setup, troubleshooting, and maintenance of Cisco Small Business products.
Q. How do I set the SPA2100 to bridge mode?A.
Setting the SPA2100 to bridge mode
There are two ways to configure the unit in bridge mode.
Setting the SPA3102 to bridge mode using the IVR
- Setting the SPA3102 to bridge mode using the setup page
Setting the SPA2100 to bridge mode using the IVR
In order to set-up SPA2100 to bridge mode using the IVR press **** 201, press 1 to enable and 0 to disable the router functionality of the unit.
Setting the SPA2100 to Bridge Mode Using the Setup Page
In order to set-up the SPA2100 to bridge mode using the web-based setup page, complete these steps:
Access the SPA2100's web-based interface. For instructions, click here.
When the SPA2100's web-based setup page appears, click Admin Login then advanced on the upper right-hand corner.
Click Lan Setup and change Enable DHCP Server to no.
The Cisco Support Community is a forum for you to ask and answer questions, share suggestions, and collaborate with your peers.
Refer to Cisco Technical Tips Conventions for information on conventions used in this document.