This article is one in a series to assist in the setup, troubleshooting, and maintenance of Cisco Small Business products.
Q. How do I setup call forwarding on the PAP2?A.
Note: This procedure only applies to all incoming call that has to be forwarded in a specific or extension number.
Access the PAP2's web-based setup page. For instructions, click here.
Click USER1 and look for Call Forward Settings. Under Cfwd All Dest enter the number or extension number where you want to forward all incoming calls.
Note: In order to forward incoming calls after a specific number of rings (for example, 2 to 3 rings) in a certain extension number, complete these steps:
Look for Cfwd No Ans Dest, and enter the extension number where you wanted to forward the call.
Note: Cfwd No Ans Delay can be set to the desired number of rings you want before forwarding the call (for example, 20 seconds is equivalent to four rings). You can set it to 10 if you want two rings and call will be forwarded right away to the number you specify under Cfwd No Ans Dest. Each ring is equivalent to five seconds.
Click Save Settings.
The Cisco Support Community is a forum for you to ask and answer questions, share suggestions, and collaborate with your peers.
Refer to Cisco Technical Tips Conventions for information on conventions used in this document.