What can I do if I can make a phone call but cannot hear ringing using a PAP2?
This article is one in a series to assist in the setup, troubleshooting, and maintenance of Cisco Small Business products.
Q. What can I do if I can make a phone call but cannot hear ringing using a PAP2?A.
Resolving Difficulty with Phone not Ringing
Access the PAP2's web-based setup page. For instructions, click here.
When the PAP2's web-based setup page appears, click Admin Login then switch to advanced view.
Click Regional, look for theRing and Call Waiting Tone Spec section and set Ring Waveform to Trapezoid. Set Ring Frequency to 20 and CPC Delay to 10.
Click Save Settings.
The Cisco Support Community is a forum for you to ask and answer questions, share suggestions, and collaborate with your peers.
Refer to Cisco Technical Tips Conventions for information on conventions used in this document.