Cisco Small Business Voice Gateways and ATAs (Linksys Business Series)

Document ID: 108733

Contents

Introduction
How to set the SPA3102 to bridge mode?
Related Information

Introduction

This article is one in a series to assist in the setup, troubleshooting, and maintenance of Cisco Small Business products (formerly Linksys Business Series).

Q. How to set the SPA3102 to bridge mode?

There are two ways to set the device to Bridge Mode:

• Setting the SPA3102 to Bridge Mode using the IVR
• Setting the SPA3102 to Bridge Mode using the web-based setup page

Setting the SPA3102 to Bridge Mode using the IVR
To set the SPA3102 to Bridge Mode using the IVR, dial **** 201. The user will now be able to press 1 to enable or 0 to disable the device's router functionality.

Setting the SPA3102 to Bridge Mode using the web-based setup page
To set the SPA3102 to Bridge Mode using the web-based setup page, follow the steps below.

Step 1:
Access the SPA3102's web-based setup page. For instructions click here.

Step 2:
When the SPA3102's web-based setup page appears, click advanced and then Lan Setup.

Step 3:
Under Networking Service, select Bridge from the drop-down menu.



Step 4:

Click on .

Related Information

• Technical Support & Documentation - Cisco Systems