Document ID: 108726
Contents
Introduction
What can I do to enable the SPA3000 Auto PSTN Fallback?
Related Information
Introduction
This article is one in a series to assist in the setup, troubleshooting, and maintenance of Cisco Small Business products (formerly Linksys Business Series).
Q. What can I do to enable the SPA3000 Auto PSTN Fallback?
A.The SPA3000 Auto PSTN Fallback works when it is set to yes. You should be able to dial local numbers when you have the device powered off (power failure or physically off) without dialing a prefix number 9 as shown on the dial plan.
Step 1:
Access the SPA3000's web-based setup page. For instructions, click here.Step 2:
Click Admin Login then advanced.
Step 3:
Click Line 1 and look for VoIP Fallback To PSTN and set Auto PSTN Fallback to yes.
Step 4:
Click
.
Related Information
| Updated: Dec 12, 2008 | Document ID: 108726 |