Cisco Small Business Voice Gateways and ATAs

This article is one in a series to assist in the setup, troubleshooting, and maintenance of Cisco Small Business products (formerly Linksys Business Series).

A. Complete these steps in order to enable WAN access to the SPA3102:

1. Connect an analog telephone to the PHONE 1 port of the SPA3102.

2. Pick up the handset and press the star key (*) four times: ****

3. After the greeting plays, dial 110# in order to retrieve the IP address of the SPA3102.

4. Complete these steps in order to enable WAN access to the SPA3102:

   1. Dial 7932#.

   2. Dial 1# to enable.

   3. Dial 1 to save.

5. Hang up the handset.

A. There are two sections that must be saved separately: the routing/networking configuration and the voice configuration.

• Routing/Networking Configuration

  1. Open a browser, and enter http://<device_IP_address>/admin/advanced.

  2. Use the Save As feature on your browser in order to write the configuration to a single file.

     • In Internet Explorer, choose File > Save As, and then choose Web Page from the Save as type drop-down list.

     • In FireFox, choose File > Save Page As, and then choose Web Page from the Save as type drop-down list.

  3. Save the file with this naming convention: SPA3102Router_date_time.html

     For example: SPA3102Router_Feb182009_09h18.html

• Voice Configuration

  1. Open a browser, and enter http://<device_IP_address>/admin/voice/advanced.

  2. Use the Save As feature on your browser in order to write the configuration to a single file.

     • In Internet Explorer, choose File > Save As, and then choose Web Page from the Save as type drop-down list.

     • In FireFox, choose File > Save Page As, and then choose Web Page from the Save as type drop-down list.

  3. Save the file with this naming convention: SPA3102Voice_date_time.html

     For example: SPA3102Voice_Feb182009_09h18.html

  Note: Once the configurations are saved, your passwords do not display on the front page.