Table Of Contents

RST Commands

20.1  RST-<MOD2>

20.2  RST-EQPT

RST Commands

---

This chapter provides restore (RST) commands for the Cisco ONS 15454 SDH.

20.1  RST-<MOD2>

The Restore 10GFC, 10GIGE, 1GFC, 1GFICON, 2GFC, 2GFICON, CLNT, D1VIDEO, DS3I, DV6000, E1, E3, E4, ESCON, ETRCLO, FSTE, G1000, GFPOS, GIGE, HDTV, ISC1, STM4, STM64, STM1, STM16, OCH, OMS, OTS, POS, STM1E, VC3, VC44C, VC38C, VC464C, VC48C, STS36C, VC4, VC416C, VC42C, VC43C, VC11, or VC12 (RST-<MOD2>) command provisions a facility in service. See Table 27-1 for supported modifiers by platform.

Usage Guidelines

None

Category

Ports

Security

Maintenance

Input Format

RST-<MOD2>:[<TID>]:<AID>:<CTAG>::::[<PST>[,<SST>]];

Input Example

RST-E1:CISCO:FAC-1-1:1::::UNLOCKED,AUTOMATICINSERVICE;

Input Parameters

<AID>	Access identifier from the "ALL" section.
<PST>	(Optional) Primary state. The parameter type is PST, which indicates the current overall service condition of an entity.
•Unlocked	In service
•Locked	Out of service
<SST>	(Optional) Secondary state. The parameter type is SST, which provides additional information pertaining to PST and PSTQ.
•AutomaticInService	Automatic in service
•Disabled	Disabled
•Loopback	Loopback
•MismatchofEquipmentAlarm	Mismatch of equipment and attributes
•Maintenance	Maintenance mode
•OutOfGroup	Out of group
•SoftwareDownload	Software downloading
•Unassigned	Unassigned
•NotInstalled	Unequipped

20.2  RST-EQPT

The Restore Equipment (RST-EQPT) command provisions equipment into the In Service state from the Maintenance state.

Usage Guidelines

Only applicable to equipment that is in transition from the Maintenance state to the In-Service state.

Category

Equipment

Security

Maintenance

Input Format

RST-EQPT:[<TID>]:<AID>:<CTAG>[::];

Input Example

RST-EQPT:CISCO:SLOT-1:1;

Input Parameters

<AID>

Access identifier from the "EQPT" section.