Note The terms "Unidirectional Path Switched Ring" and "UPSR" may appear in Cisco literature. These terms do not refer to using Cisco ONS 15xxx products in a unidirectional path switched ring configuration. Rather, these terms, as well as "Path Protected Mesh Network" and "PPMN," refer generally to Cisco's path protection feature, which may be used in any topological network configuration. Cisco does not recommend using its path protection feature in any particular topological network configuration.
This manual provides reference information for the Cisco ONS 15454 SDH.
To install, turn up, provision, and maintain a Cisco ONS 15454 SDH node and network, refer to the Cisco ONS 15454 SDH Procedure Guide.
For alarm clearning, general troubleshooting,and hardware replacement procedures, refer to the Cisco ONS 15454 SDH Troubleshooting Guide.
Revision History
Date
Notes
04/06/2007
Revision History Table added for the first time.
10/23/2007
Updated About this Manual chapter.
Document Organization
The following table describes the contents of the Cisco ONS 15454 SDH Reference Guide.
Table 1 Cisco ONS 15454 SDH Reference Manual Chapters
Includes VC4, VC3, and VC12, bidirectional or unidirectional, revertive or non-revertive, electrical or optical, multiple and path trace circuit information
Includes the SDH configurations used by the ONS 15454 SDH; including MS-SPRs, SNCPs, linear ADMs, subtending rings, and optical bus configurations, as well as information about upgrading optical speeds within any configuration
Explains Simple Network Management Protocol (SNMP) as implemented by the Cisco ONS 15454 SDH.
Obtaining Documentation and Submitting a Service Request
For information on obtaining documentation, submitting a service request, and gathering additional information, see the monthly What's New in Cisco Product Documentation, which also lists all new and revised Cisco technical documentation, at:
Subscribe to the What's New in Cisco Product Documentation as a Really Simple Syndication (RSS) feed and set content to be delivered directly to your desktop using a reader application. The RSS feeds are a free service and Cisco currently supports RSS version 2.0.