The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
This chapter describes the Cisco NX-OS Virtual Router Redundancy Protocol (VRRP) commands that begin with S.
To disable a Virtual Router Redundancy Protocol (VRRP) configuration, use the shutdown command. To enable a VRRP configuration, use the no form of this command.
shutdown
no shutdown
This command has no arguments or keywords.
Disabled
VRRP configuration mode
|
|
---|---|
5.0(3)N1(1) |
This command was introduced. |
Shut down the virtual router before configuring the virtual router parameters; you can only configure the virtual router after it is in the administrative shut down state. Enter the no shutdown command to update the virtual router state after completing configuration.
This example shows how to shut down a VRRP group:
switch# configure terminal
switch(config)# interface ethernet 2/3
switch(config-if)# no switchport
switch(config-if)# vrrp 45
switch(config-if-vrrp)# shutdown
switch(config-if-vrrp)# address 6.6.6.45
switch(config-if-vrrp)# no shutdown
switch(config-if-vrrp)#
|
|
---|---|
feature vrrp |
Enables VRRP. |
show vrrp |
Displays VRRP configuration information. |
clear vrrp |
Clears all the software counters for the specified virtual router. |