The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
This chapter describes the Cisco NX-OS Enhanced Interior Gateway Routing Protocol (EIGRP) commands that begin with L.
To enable the logging of changes in the Enhanced Interior Gateway Routing Protocol (EIGRP) adjacency state, use the log-adjacency-changes command. To disable the logging of changes in the EIGRP adjacency state, use the no form of this command.
log-adjacency-changes
no log-adjacency-changes
This command has no arguments or keywords.
Adjacency changes are not logged.
Address-family configuration mode
Router configuration mode
Router VRF configuration mode
|
|
---|---|
5.0(3)N1(1) |
This command was introduced. |
This command requires the LAN Base Services license.
This example shows how to enable logging of adjacency state changes for EIGRP 1:
switch(config)# router eigrp 1
switch(config-router)# address-family ipv4
switch(config-router-af)# log-adjacency-changes
switch(config-router-af)#
To enable the logging of Enhanced Interior Gateway Routing Protocol (EIGRP) neighbor warning messages, use the log-neighbor-warnings command. To disable the logging of EIGRP neighbor warning messages, use the no form of this command.
log-neighbor-warnings [seconds]
no log-neighbor-warnings [seconds]
seconds |
(Optional) Time interval (in seconds) between repeated neighbor warning messages. The range of seconds is from 1 to 65535. |
Neighbor warning messages are logged.
Address-family configuration mode
Router configuration mode
Router VRF configuration mode
|
|
---|---|
5.0(3)N1(1) |
This command was introduced. |
Use the log-neighbor-warnings command to enable neighbor warning messages and to configure the interval between repeated neighbor warning messages.
This command requires the LAN Base Services license.
This example shows how to log neighbor warning messages for EIGRP process 209 and to repeat the warning messages in 5-minute (300 seconds) intervals:
switch(config)# router eigrp 209
switch(config-router)# log-neighbor-warnings 30
switch(config-router)#
|
|
---|---|
log-adjacency-changes |
Enables logging of EIGRP adjacency state changes. |
show ip eigrp interfaces |
Displays information about EIGRP interfaces. |