Cisco MSE Virtual Appliance Installation Guide for CMX Release 10.1

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Book Contents

Find Matches in This Book

Results

Updated:: May 4, 2015

Chapter: Cisco MSE Installation Commands

MSE Installation Commands

Cisco MSE Installation Commands

This appendix lists some of the MSE commands that you use while deploying the MSE virtual appliance.

MSE Installation Commands

Use these commands to install, configure, and monitor tasks while deploying the MSE virtual appliance.

Table A-1 MSE Commands
Command	Explanation
cmxctl node install	Installs MSE for the first time.
cmxctl status	Displays the status of the services.
cmxctl config maps import	Imports map from the Prime Infrastructure.
cmxctl config maps delete	Deletes the campus map.
cmxctl config controllers add	Adds controller to CMX.
cmxctl config controllers delete	Deletes the controller.
cmxctl config controllers show	Shows the controller version that has been added
cmxctl config import status	Displays status of the import
cmxctl version	Print the current MSE version information.

Was this Document Helpful?

Feedback

Contact Cisco

Open a Support Case
(Requires a Cisco Service Contract)