Managing Access Points
Starting Release 8.4, Cisco Mobility Express supports up to 100 Access Points. To view the list or modify parameters on an Access Points, follow the procedure below:
Navigate to Wireless Settings > Access Points.
To modify the parameters on an access point, click on the Edit button. The Access Point window will come up displaying the General parameters about the Access Point.
Under the Controller tab (Available only for Master AP), one can modify the following parameters:
Under Radio 1 (2.4 GHz) and Radio 2 (5 GHz), one can edit the following parameters:
This is a logarithmic scale of the transmit power, that is the transmission energy used by the AP, 1 being the highest,2 being half of it, 3 being 1/4th and so on. Selecting Automatic adjusts the radio transmitter output power based on the varying signal level at the receiver. This allows the transmitter to operate at less than maximum power for most of the time; when fading conditions occur, transmit power will be increased as needed until the maximum is reached.