On-Premises Phone Headset Customization
After you personalize your headset settings, the phone saves the settings and applies them to any other Cisco headset model.
Adjust Your Bass and Treble
Procedure
Step 1 |
Press Applications . |
Step 2 |
Select . |
Step 3 |
Press Setup and select . |
Step 4 |
Press the Navigation cluster, left or right, to adjust the tuning. |
Adjust Your Speaker Feedback
Procedure
Step 1 |
Press Applications . |
Step 2 |
Select . |
Step 3 |
Select . |
Step 4 |
Press the Navigation cluster, up or down, to adjust the sidetone. |
Step 5 |
Select Set to apply your settings. |
Adjust Your Microphone Volume
Procedure
Step 1 |
Press Applications . |
Step 2 |
Select . |
Step 3 |
Press Setup and select . |
Step 4 |
Press the Navigation cluster, left or right, to adjust the gain. |
Test Your Microphone
Procedure
Step 1 |
Press Applications . |
Step 2 |
Select . |
Step 3 |
Press Setup and select . |
Step 4 |
Press Record and speak into the microphone. |
Step 5 |
Press Stop rec when you finish speaking. |
Step 6 |
Press Play to review your test recording. |
Enable Electronic Hookswitch Control on Your Phone
If your administrator has enabled Admin settings on your Cisco IP Phone, you can enable or disable electronic hookswitch control to connect with a Cisco Headset 560 Series base. Electronic hookswitch control is enabled by default.
Note |
This feature is available on Cisco IP Phone Firmware Release 12.7(1) and later. |
Procedure
Step 1 |
On your phone, press Applications . |
Step 2 |
Navigate . |
Step 3 |
Select Connect e-hook headset to enable electronic hookswitch control. |
Change Your Headset Ringer Settings
Procedure
Step 1 |
Press Applications . |
Step 2 |
Select . |
Step 3 |
Select a ringer setting. By default, your phone follows the behavior of the phone ringer settings. Select On if you want to always hear the phone ring when you have an incoming call. If you select Off, you won't hear any ring through your headset when there is an incoming call. |
Step 4 |
Select Set to apply your settings. |
Reset Cisco Headset Settings from Your Phone
You can reset your Cisco headset to remove your custom settings. This action returns the headset to the original configuration set by your administrator.
Your phone must be running Firmware Release 12.5(1)SR3 or later for this feature to function.
Before you begin
Connect your headset to the phone:
-
Cisco Headset 520 Series: Connect with the USB adapter
-
Cisco Headset 530 Series: Connect with the USB cable
-
Cisco Headset 560 Series: Connect the standard base or multibase with the USB or Y-cable.
Procedure
Step 1 |
On the phone, press Applications . |
Step 2 |
Select . |
Step 3 |
At the warning window, select Reset. |