add the switch to the Emergency Responder configuration.
Responder asks if you want to run the switch port and phone update process. You
must run this process so that Emergency Responder can identify the ports on the
switch and so that your ERL administrator can then assign the ports to the
If you are
adding more than one switch, you can skip running the process until you add the
last switch. When you select to run the process, Emergency Responder runs the
process on all switches added since the last time the switch port and phone
update process was run.
If you do not
choose to run the process, you can run it later by selecting
> Run Switch-Port & Phone Update.
In either case,
newly discovered ports are assigned to the Default ERL.
Responder expects only one IP address or hostname per chassis and needs access
to the following MIBs:
Click a switch
in the LAN Switches list to view the switch's Emergency Responder
configuration. To change the configuration, make your changes and click
to add another switch if you are viewing an existing switch's
To delete a
switch, select it from the LAN Switches list and click
If you do not remove the switch from the network, Emergency Responder
identifies any phones connected to the switch as unlocated phones.