A Cisco UCS 6300
Series Fabric Interconnect provides network connectivity and management
capabilities for the UCS system. The UCS 6300 Series Fabric Interconnect
supports the management of power supplies, fans, and blade servers in the UCS
5108 Server Chassis. When connected to the UCS 2304 I/O module, a UCS 6300
Series Fabric Interconnect provides an end-to-end 40-Gigabit Ethernet and
16-Gigabit Fibre Channel architecture.
The UCS 6332
Fabric Interconnect is a 1 rack unit (RU) is 32-port Ethernet or FCoE chassis
that provides 40-Gigabit Ethernet switching.
The UCS 6332-16UP
Fabric Interconnect is a 1 RU chassis that supports Ethernet, FCoE, and and
Fibre Channel. It has 16 Fibre Channel ports and 24 40-Gigabit QSFP+ ports.
Server Port Link
When cables of server
ports are removed from the Fabric Interconnect, Cisco UCS Manager displays a
message indicating that the link is down because of link failure or not
connected. Before the cable is plugged back in, a false "[F0276][cleared]"
event might be logged after 20 to 30 seconds.
When a port that is Up
gets disconnected, it transitions to a Link Down status.
When a port has a
Link Down status, it checks if an SFP is inserted.
If an SFP is
inserted, the port status remains at Link Down, and the F0276 event is not
cleared. This situation occurs when the SFP cable is plugged into the Fabric
Interconnect port, and the SFP at the I/O module is disconnected.
The "Link down or
not connected" fault appears, and the fault is not cleared until the SFP is
plugged back into the I/O module port.
If there is no SFP
detected, the port status transitions from Link Down status to SFP Not Present.
This situation occurs when the SFP is plugged into the I/O module and the other
end is not plugged into the Fabric Interconnect port that is configured to be
When the port
status is no longer Link Down, the F0276 is cleared.
System Hardware Best Practices
Installation Best Practices
When installing the chassis, follow these best practices:
Plan your site configuration and prepare the site before installing the chassis.
Verify that you have the appropriate power supplies for your chassis configuration.
Install the chassis following the rack and airflow guidelines presented in this guide.
Verify that the chassis is adequately grounded.
Initialization Best Practices
When the initial system boot is complete, verify the following:
Power supplies are supplying power to the system.
Fan modules are operating normally.
The system software boots successfully.
System Operation Best Practices
To ensure proper operation of your system, take the following actions:
Make a copy of the running configuration to CompactFlash for a safe backup.
Never use the init system CLI command unless you understand that you will lose the running and startup configuration as well as the files stored on bootflash:.