New and Changed Information
|
Feature |
Description |
Changed in Release |
Where Documented |
|---|---|---|---|
| Multicast Consistency Checker | Added support for IPv6 L2/L3 Multicast consistency checker |
10.1(1) |
|
| Layer 2 Switchport Interface Consistency Checker |
Added all option to the following command:
|
9.3(5) |
Consistency Checker Commands |
| VLAN Consistency Checker |
Added interface option to the following commands:
|
9.3(5) |
Consistency Checker Commands |
| Multicast Consistency Checker | Added additional supported platforms |
9.3(5) |
|
|
Consistency Checker Enhancements |
Added enhancements to the following commands:
|
9.3(5) |
Consistency Checker Commands |
|
Segment Routing Consistency Checker Commands |
Added the following commands:
|
9.3(5) |
Consistency Checker Commands |
|
ACL Consistency Checker Enhancements |
Added additional supported platforms |
9.3(5) |
|
| Serviceability Enhancements | Added support for several counters to monitor and log fibre channel interfaces. The counters help identify and troubleshoot issues at FCMAC level. |
9.3(3) |
Using OBFL Error Status Command |
| Consistency Checker Enhancements | Consistency Checker Enhancements. Added VXLAN consistency checker commands |
9.3(3) |
Consistency Checker Commands |
| Slow Drain Detection and Congestion Isolation | Added support to show tech-support slowdrain command to troubleshoot congestion issues. |
9.3(3) |
Congestion Detection and Avoidance |
| Multicast Consistency Checker |
Added support for Cisco Nexus 9300-GX Series switch. |
9.3(3) |
|
|
ACL Consistency Checker |
Added support for ACL Consistency Checker |
9.3(3) |
|
| Consistency Checker Enhancements | Consistency Checker Enhancements |
9.3(1) |
Consistency Checker Commands |
| Multicast Consistency Checker | Added support for Multicast Consistency Checker |
9.3(1) |
|
|
Collecting system information and configuration with show tech-support detail [time-optimized | space-optimized] command |
Added support for show tech-support detail [time-optimized | space-optimized] command |
9.3(1) |
Feedback