Configuring Unidirectional Ethernet

This chapter describes how to configure Unidirectional Ethernet on the Cisco Nexus 9000 series switches.

Unidirectional Ethernet (UDE) Overview

Unidirectional Ethernet uses only one strand of fiber for either transmitting or receiving one-way traffic, instead of two strands of fiber.

With unidirectional links either transmit or receive traffic for applications, such as video streaming, where most traffic sent is unacknowledged.You can create a unidirectional link by configuring ports equipped with bidirectional transceivers to unidirectionally transmit or receive traffic. You can use UDE when there is no appropriate unidirectional transceiver available. For example, without supported transmit-only transceivers, you must configure transmit-only links with software-based UDE.

Guidelines and Limitations for Unidirectional Ethernet

  • UDE send-only is supported.

  • UDE receive-only is not supported till Cisco NX-OS Release 10.1(1).

  • UDE can be enabled on all ports simultaneously.

  • UDE at hardware level is supported only on Cisco Nexus 9500 switches with X97160YC-EX line cards.

  • UDE is supported only for native 10G-LR/10G-LRS transceivers, and cannot be used with QSAs or breakout cables.

  • Port flap may occur when you configure UDE on a port.

  • You can add physical interfaces with and without UDE configuration into a port-channel. However, you must ensure only send-only interfaces are added to a port-channel. UDE may not work as expected if you mix send-only configuration with other interfaces.

  • The port-channel may not receive packets if all members are configured as UDE send-only.

  • The port-channel may not receive packets if all members are configured as UDE send-only which can prevent LCAP based port-channel to come up.

  • Special control plane traffic pruning is not configured on send-only ports.

  • Unidirectional ports do not support any features or protocols that require negotiation with the port at the other end of the link. You must disable all features that require bi-directional communication.

Configuring Unidirectional Ethernet

To configure unidirectional ethernet, follow these steps:

SUMMARY STEPS

  1. configure terminal
  2. interface ethernet {type slot /port}
  3. unidirectional send-only
  4. exit
  5. show running-config interface {type slot /port}
  6. copy running-config startup-config

DETAILED STEPS

  Command or Action Purpose

Step 1

configure terminal

Example:

switch# configure terminal
switch(config)#

Enters global configuration mode.

Step 2

interface ethernet {type slot /port}

Example:

switch(config)# interface ethernet 3/1

Specifies an interface to configure, and enters interface configuration mode.

Step 3

unidirectional send-only

Example:

switch(config)# unidirectional send-only 

Configures uni-directional transmit (send only) mode.

Step 4

exit

Example:

switch(config)# exit

Exits interface mode.

Step 5

show running-config interface {type slot /port}

Example:

switch(config)# show running-config interface ethernet 3/1

Displays configuration information about the specified interface.

Step 6

copy running-config startup-config

Example:

switch(config)# copy running-config startup-config

Copies the running configuration to the startup configuration