The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
This chapter describes the Cisco NX-OS object tracking commands that begin with D.
To delay a state change for object tracking, use the delay command. To disable this function, use the no form of this command.
delay {up up-time [down down-time] | down down-time [up up-time]}
no delay
None
Object track mode
|
|
---|---|
5.0(3)N1(1) |
This command was introduced. |
Use the delay command to delay when object tracking detects an up or down state change for a tracked object or track list. This delay helps to prevent state flapping.
This example shows how to configure the delay timer for a tracked object:
switch(config)# configure terminal
switch(config)# track 1 interface ethernet 1/2 line-protocol
switch(config-track)# delay up 30 down 30
switch(config-track)#
|
|
---|---|
track |
Configures a tracked object or track list. |