1.
Ensure that the switch is on. Switches in the Cisco Nexus series
boot automatically.
2.
Enter the new password for the administrator.
3.
Enter
yes to enter the setup mode.
4.
Enter the new password for the administrator (admin is the
default).
5.
Enter
yes (no is the default) to create additional
accounts.
6.
Enter
yes (yes is the default) to create an SNMP
read-only community string.
7.
Enter a name for the switch.
8.
Enter
yes (yes is the default) to configure
out-of-band management and enter the mgmt0 IPv4 address.
9.
Enter
yes (yes is the default) to configure the IPv4
default gateway (recommended) and enter the IPv4 address for the default
gateway.
10.
Enter
yes (yes is the default) to enable the Telnet
service.
11.
Enter
yes (no is the default) to enable the SSH
service.
12.
Enter
yes (no is the default) to configure the NTP
server and enter the IPv4 address for the NTP server.
13.
Enter
yes (yes is the default) to configure basic
Fibre Channel configurations.
14.
Enter
shut (shut is the default) to configure the
default Fibre Channel switch port interface to the shut (disabled) state.
15.
Enter
on (on is the default) to configure the switch
port trunk mode.
16.
Enter
permit (deny is the default) to deny a default
zone policy configuration.
17.
Enter
yes (no is the default) to enable a full zone
set distribution.
18.
You see the new configuration. Review and edit the configuration
that you have just entered. Enter
no (no is the default) if you are satisfied
with the configuration.
19.
Enter
yes (yes is default) to use and save this
configuration: