The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
This chapter describes the Cisco NX-OS virtual port channel (vPC) commands that begin with A.
To discard the current switch profile configuration, use the abort command.
abort
This command has no arguments or keywords.
None
Switch profile configuration mode
|
|
---|---|
5.2(1)N1(1) |
This command was introduced. |
Use this command when you want to discard the configuration that is imported to a switch profile.
This example shows how to discard a configuration on a switch profile named s5010 on switch 1 of the peer:
switch# config sync
Enter configuration commands, one per line. End with CNTL/Z.
switch(config-sync)# switch-profile s5010
Switch-Profile started, Profile ID is 1
switch(config-sync-sp)# import running-config
switch(config-sync-sp-import)# exit
switch(config-sync-sp)# abort
switch(config-sync-sp)#
To configure the time to restore the virtual port channel (vPC) peer links, use the auto-recovery command. To revert to the default delay value, use the no form of this command.
auto-recovery [reload-delay delay_value]
no auto-recovery [reload-delay delay_value]
240 seconds
vPC domain configuration mode
|
|
---|---|
5.0(2)N2(1) |
This command was introduced. |
This example shows how to enable the automatic recovery interval for 240 seconds (the default value) in vPC domain 100:
switch# configuration terminal
switch(config)# vpc domain 100
switch(config-vpc-domain)# auto-recovery
Warning:
Enables restoring of vPCs in a peer-detached state after reload, will wait for
240 seconds (by default) to determine if peer is un-reachable
switch(config-vpc-domain)#
This example shows how to set the automatic recovery delay period for 300 seconds in vPC domain 200:
switch# configuration terminal
switch(config)# vpc domain 200
switch(config-vpc-domain)# auto-recovery reload-delay 300
Warning:
Enables restoring of vPCs in a peer-detached state after reload, will wait for
240 seconds (by default) to determine if peer is un-reachable
switch(config-vpc-domain)#
|
|
---|---|
vpc domain |
Configures a vPC domain. |
show running-config vpc |
Displays the running configuration information for vPCs. |