This chapter describes the Cisco NX-OS commands that begin with L that are used to manage a Cisco Nexus 2000 Series Fabric Extender from a Cisco Nexus 5500 switch.
To turn on the locator LED of a Fabric Extender, use the locator-led command. To turn off the locator LED, use the no form of this command.
locator-led fex Blink fex_number
no locator-led fex Blink fex_number
|
|
---|---|
Use the locator-led command to toggle the locator LED of a Fabric Extender, which allows you to easily identify the machine in a busy data center.
This example shows how to turn on the locator LED for a specific Fabric Extender chassis:
This example shows how to turn off the locator beacon LED for a specific Fabric Extender chassis:
|
|
---|---|
Displays all configured Fabric Extender chassis connected to the switch. |
|
Displays the status of the locator LED in Fabric Extender modules. |
To turn on the locator LED of a Fabric Extender, use the locator-led command. To turn off the locator LED, use the no form of this command.
|
|
---|---|
Use the locator-led command to toggle the locator LED of a Fabric Extender, which allows you to easily identify the machine in a busy data center.
This example shows how to turn on the locator LED for a specific Fabric Extender chassis:
This example shows how to turn off the locator beacon LED for a specific Fabric Extender chassis:
|
|
---|---|
Displays all configured Fabric Extender chassis connected to the switch. |
|
Displays the status of the locator LED in Fabric Extender modules. |
To set the logging alert level for Fabric Extender events, use the logging fex command. To reset the logging level, use the no form of this command.
logging fex [ severity-level ]
no logging fex [ severity-level ]
(Optional) Number of the desired severity level at which messages should be logged. Messages at or numerically lower than the specified level are logged. Severity levels are as follows: |
|
|
This example shows how to set the logging alert level for Fabric Extender events:
switch(
config)#
logging fex 4
This example shows how to reset the logging level:
switch(
config)#
no logging fex
|
|
---|---|
Displays all configured Fabric Extender chassis connected to the switch. |