This chapter describes the Cisco NX-OS FabricPath commands that begin with I.
To install the FabricPath feature set on the switch, use the install feature-set fabricpath command. To remove the FabricPath feature set, use the no form of this command.
install feature-set fabricpath
no install feature-set fabricpath
This command has no arguments or keywords.
Disabled
Global configuration mode
|
|
---|---|
5.2(1)N1(1) |
This command was introduced. |
Note The FabricPath feature is supported only on the Cisco Nexus 5500 Series switches.
This command requires an Enhanced Layer 2 license.
This example shows how to install the FabricPath features on the switch:
switch# configure terminal
switch(config)# install feature-set fabricpath
switch(config)#