interface ethernet
To enter interface configuration mode for an Ethernet IEEE 802.3 interface, use the interface ethernet command.
interface ethernet [chassis_ID / ] slot / port
Syntax Description
chassis_ID |
(Optional) Specifies the Fabric Extender chassis ID. The chassis ID is from 100 to 199.
|
||
slot |
Slot from 1 to 3. The following list defines the slots available:
|
||
port |
Port number within a particular slot. The port number is from 1 to 128. |
Command Default
None
Command Modes
Global configuration mode
Command History
Release |
Modification |
---|---|
4.0(0)N1(1a) |
This command was introduced. |
4.0(1a)N2(1) |
This command was modified to provide the chassis ID argument. |
5.0(3)N1(1) |
Support for Layer 3 interfaces was added. |
Examples
This example shows how to enter configuration mode for Ethernet interface 1/4:
switch(config)# interface ethernet 1/4
switch(config-if)#
This example shows how to enter configuration mode for a host interface on a Fabric Extender:
switch(config)#interface ethernet 101/1/1
switch(config-if)#