The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
This chapter describes the system management commands that begin with M.
To configure the maximum transmission unit (MTU) truncation size for packets in the specified Ethernet Switched Port Analyzer (SPAN) session, use the mtu command. To remove the MTU truncation size configuration, use the no form of this command.
Monitor configuration (config-monitor)
|
|
---|---|
MTU truncation and the SPAN rate limit cannot be enabled for the same SPAN session. If you configure both for one session, only the rate limit is allowed on F1 Series modules, and MTU truncation is disabled until you disable the rate limit configuration.
Note MTU turncation is supported only on F1 Series modules and F2 Series modules.
This example shows how to configure the MTU truncation size for packets in the specified SPAN session:
This example shows how to remove the MTU truncation size configuration for packets in the specified SPAN session:
|
|
---|---|
Places you in the monitor configuration mode for configuring a SPAN session. |
|