- Preface
- Cisco Nexus 5500 Platform Overview
- Installing the Cisco Nexus 5000 Series Switch
- Connecting the Switch
- Replacing Components
- Cabinet and Rack Installation
- Technical Specifications
- Cable and Port Specifications
- LEDs
- Troubleshooting Hardware Components
- Accessory Kits
- Site Planning and Maintenance Records
Cisco Nexus 5000 Series Hardware Installation Guide
Bias-Free Language
The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
- Updated:
- November 4, 2014
Chapter: Cable and Port Specifications
Cable and Port Specifications
This appendix provides cable and port specifications for all of the Cisco Nexus 5000 Series switches.
Console Cable
Note
This section applies to the Cisco Nexus 5000 Series switches.
The console cable has a RJ-45, RS-232 connector on one end and a DB9 connector on the other end. See Figure C-1.
Cable RJ-45 Connector Pinouts
Table C-1 lists the pinouts for the RJ-45 connector on the console cable.
|
|
|
|
|
|---|---|---|---|
Console Port
Note This section applies to the Cisco Nexus 5500 Platform switches and the Cisco Nexus 5000 Platform switches.
The console port is an asynchronous RS-232 serial port with an RJ-45 connector.
Console Port Pinouts
Table C-2 lists the pinouts for the console port on the Cisco Nexus 5548 switch and the Cisco Nexus 5020 switch.
|
|
|
|---|---|
Table C-3 lists the pinouts for the console port on the Cisco Nexus 5010 switch.
|
|
|
|---|---|
Supported Power Cords and Plugs
Each power supply has a separate power cord. Standard power cords or jumper power cords are available for connection to a power distribution unit that has IEC 60320 C19 outlet receptacles. The standard power cords have an IEC C13 connector on the end that plugs into the switch. The optional jumper power cords, for use in cabinets, have an IEC C13 connector on the end that plugs into the switch and an IEC C14 connector on the end that plugs into an IEC C13 outlet receptacle.
Note Only the regular power cords or jumper power cords provided with the switch are supported.
Note If you do not order the optional power cord with the system, you are responsible for selecting the appropriate power cord for the product. Using a non-compatible power cord with this product may result in electrical safety hazard. Orders delivered to Argentina, Brazil, and Japan must have the appropriate power cord ordered with the system.
Table C-4 lists the power cords and provides their lengths in feet and meters. Table C-5 lists the power cables for the HVAC/HVDC power supplies (NXA-PHV-1100W and NXA-PHV-1100W-B) that are available for the Cisco Nexus 5596 switch.
Jumper Power Cord
Figure C-16 shows the plug connector on the optional jumper power cord for the Cisco Nexus 5000 Series switches. This cable plugs into the power supply, and the receptacle of a power distribution unit for a cabinet. This cable comes in 6- and 9-foot (2- and 3-meter) lengths.
Figure C-16 CAB-C13-C14-JMPR, Jumper Power Cord
Feedback