Upgrading to Cisco NX-OS Release 10.6(x)
You can upgrade the Cisco Nexus 3550-T switch to Cisco NX-OS Release 10.6(x) from:
-
Exablaze ExaOS
Note
If you are on ExaOS, refer to Cisco Nexus 3550-T NX-OS Software Installation and Upgrade Guide, Release 10.2(x) for instructions on upgrading to 10.2.3v from ExaOS, and then follow the instructions in the Upgrading from Cisco NX-OS Release 10.2(3v) to Cisco NX-OS Release 10.6(x) section to upgrade to 10.6(x).
-
Cisco NX-OS Release 10.2(3v)
Upgrading from Cisco NX-OS Release 10.2(3v) to Cisco NX-OS Release 10.6(x)
Use this procedure to upgrade the Cisco 3550-T from NX-OS release 10.2(3v) to NX-OS release 10.6(x).
Before you begin
You need to be running the NX-OS release 10.2(3v).
Procedure
Run the boot nxos command, as shown below. Example
You can get the NX-OS release 10.6(x) image from the Software Downloads tab on Cisco.com.
|