Upgrading to Cisco NX-OS Release 10.2(x)
You can upgrade the Cisco Nexus 3550-T switch to Cisco NX-OS Release 10.2(x) from:
-
Exablaze ExaOS
-
Cisco NX-OS Release 10.1(2t)
Upgrading from ExaOS to Cisco NX-OS Release 10.2(x)
Use this procedure to upgrade the Cisco 3550-T from ExaOS to NX-OS release 10.2(x).
Procedure
Step 1 |
Migrate from ExaOS to Cisco NX-OS release 10.1(2t). For the detailed procedure, see the Cisco Nexus 3550-T NX-OS Software Installation and Upgrade Guide. You can get the NX-OS Release 10.1(2t) from the Software Downloads tab on Cisco.com or you can directly go here. |
Step 2 |
Upgrade from NX-OS release 10.1(2t) to NX-OS release 10.2(x). For the detailed procedure, see Upgrading from Cisco NX-OS Release 10.1(2t) to Cisco NX-OS Release 10.2(x). |
Upgrading from Cisco NX-OS Release 10.1(2t) to Cisco NX-OS Release 10.2(x)
Use this procedure to upgrade the Cisco 3550-T from NX-OS release 10.1(2t) to NX-OS release 10.2(3t) or to NX-OS release 10.2(3v).
Before you begin
You need to be running the NX-OS release 10.1(2t) or 10.2(3t).
Procedure
Run the boot nxos command, as shown below.
You can get the NX-OS release 10.2(x) image from the Software Downloads tab on Cisco.com. Choose the required release, 10.2(3t) or 10.2(3v).
Run the show version command to check the installed release version. Sample output for 10.2(3t):
Sample output for 10.2(3v):
|