تكوين لوحة وصل موجه إلى موجه IPSec وتحدثه

Current configuration:
!
version 12.0
service timestamps debug uptime
service timestamps log uptime
no service password-encryption
!
hostname dr_whoovie
!
enable secret 5 $1$KxKv$cbqKsZtQTLJLGPN.tErFZ1
enable password ww
!
ip subnet-zero
!
cns event-service server

!--- Configure the Internet Key Exchange (IKE) !--- policy and preshared key for each peer: !--- IKE policy defined for peers.

crypto isakmp policy 1
authentication pre-share

!--- Preshared keys for different peers.

crypto isakmp key cisco170 address 150.150.150.2 
crypto isakmp key cisco180 address 150.150.150.3 
crypto isakmp key cisco190 address 150.150.150.4 

!--- Configure the IPSec parameters: !--- IPSec transform sets.

crypto ipsec transform-set 170cisco esp-des esp-md5-hmac 
crypto ipsec transform-set 180cisco esp-des esp-md5-hmac 
crypto ipsec transform-set 190cisco esp-des esp-md5-hmac 
!
crypto map ETH0 17 ipsec-isakmp 

!--- Set the peer.

set peer 150.150.150.2

!--- The IPSec transform set is used for this tunnel.

set transform-set 170cisco 

!--- Interesting traffic for peer 150.150.150.2.

match address 170
crypto map ETH0 18 ipsec-isakmp

!--- Set the peer. 

set peer 150.150.150.3

!--- The IPSec transform set is used for this tunnel.

set transform-set 180cisco 

!--- Interesting traffic for peer 150.150.150.3.

match address 180
crypto map ETH0 19 ipsec-isakmp

!--- Set the peer. 

set peer 150.150.150.4

!--- The IPSec transform set is used for this tunnel.

set transform-set 190cisco

!--- Interesting traffic for peer 150.150.150.4.
 
match address 190
!
interface Ethernet0
ip address 150.150.150.1 255.255.255.0
no ip directed-broadcast
no ip route-cache
no ip mroute-cache
no mop enabled

!--- Apply crypto map on the interface.

crypto map ETH0
!
interface Serial0
ip address 160.160.160.1 255.255.255.0
no ip directed-broadcast
no ip mroute-cache
no fair-queue
!
ip classless
ip route 170.170.170.0 255.255.255.0 150.150.150.2
ip route 180.180.180.0 255.255.255.0 150.150.150.3
ip route 190.190.190.0 255.255.255.0 150.150.150.4
no ip http server
!

!--- Access list that shows traffic to encryption from yertle.

access-list 170 permit ip 160.160.160.0 0.0.0.255 170.170.170.0 0.0.0.255

!--- Access list that shows traffic to encryption from thidwick.

access-list 180 permit ip 160.160.160.0 0.0.0.255 180.180.180.0 0.0.0.255

!--- Access list that shows traffic to encryption from sam-i-am.

access-list 190 permit ip 160.160.160.0 0.0.0.255 190.190.190.0 0.0.0.255
dialer-list 1 protocol ip permit
dialer-list 1 protocol ipx permit
!
line con 0
transport input none
line aux 0
line vty 0 4
password ww
login
end

Current configuration:
!
version 12.0
service timestamps debug uptime
service timestamps log uptime
no service password-encryption
!
hostname Sam-I-am
!
enable secret 5 $1$HDyw$qubSJdqfIC0f1VLvHmg/P0
enable password ww
!
ip subnet-zero
!
isdn switch-type basic-5ess
isdn voice-call-failure 0
cns event-service server

!--- Configure the IKE policy and preshared key for the hub:

crypto isakmp policy 1
authentication pre-share
crypto isakmp key cisco190 address 150.150.150.1 

!--- Configure the IPSec parameters: !--- IPSec transform set.

crypto ipsec transform-set 190cisco esp-des esp-md5-hmac 

!--- Crypto map definition for the hub site.

crypto map ETH0 19 ipsec-isakmp

!--- Set the peer. 

set peer 150.150.150.1

!--- IPSec transform set.

set transform-set 190cisco

!--- Interesting traffic for peer 150.150.150.1 (hub site).
 
match address 190
!
interface Ethernet0
ip address 150.150.150.4 255.255.255.0
no ip directed-broadcast
no ip route-cache
no ip mroute-cache
no mop enabled

!--- Apply crypto map on the interface.

crypto map ETH0
!
interface Serial0
ip address 190.190.190.1 255.255.255.0
no ip directed-broadcast
no ip mroute-cache
no fair-queue
!
ip classless
ip route 160.160.160.0 255.255.255.0 150.150.150.1
no ip http server

!--- Access list that shows traffic to encryption !--- for the hub site (dr_whoovie).

access-list 190 permit ip 190.190.190.0 0.0.0.255 160.160.160.0 0.0.0.255
dialer-list 1 protocol ip permit
dialer-list 1 protocol ipx permit
!
line con 0
transport input none
line aux 0
line vty 0 4
password ww
login
!
end

Current configuration:
!
version 12.0
service timestamps debug uptime
service timestamps log uptime
no service password-encryption
!
hostname thidwick
!
enable secret 5 $1$Pcpo$fj4FNS1dEDY9lGg3Ne6FK1
enable password ww
!
ip subnet-zero
!
isdn switch-type basic-5ess
isdn voice-call-failure 0
cns event-service server

!--- Configure the IKE policy and preshared key for the hub:

crypto isakmp policy 1
authentication pre-share
crypto isakmp key cisco180 address 150.150.150.1 

!--- Configure the IPSec parameters: !--- IPSec transform set.

crypto ipsec transform-set 180cisco esp-des esp-md5-hmac 

!--- Crypto map definition for the hub site.

crypto map ETH0 18 ipsec-isakmp

!--- Set the peer.
 
set peer 150.150.150.1

!--- IPSec transform set.

set transform-set 180cisco

!--- Interesting traffic for peer 150.150.150.1 (hub site).
 
match address 180
!
interface Ethernet0
ip address 150.150.150.3 255.255.255.0
no ip directed-broadcast
no ip route-cache
no ip mroute-cache
no mop enabled

!--- Apply crypto map on the interface.

crypto map ETH0
!
interface Serial1
ip address 180.180.180.1 255.255.255.0
no ip directed-broadcast
clockrate 4000000
!
interface BRI0
no ip address
no ip directed-broadcast
shutdown
isdn switch-type basic-5ess
!
ip classless
ip route 160.160.160.0 255.255.255.0 150.150.150.1
no ip http server

!--- Access list that shows traffic to encryption !--- for the hub site (dr_whoovie).

access-list 180 permit ip 180.180.180.0 0.0.0.255 160.160.160.0 0.0.0.255
dialer-list 1 protocol ip permit
dialer-list 1 protocol ipx permit
!
line con 0
transport input none
line aux 0
line vty 0 4
password ww
login
!
end

Current configuration:
!
version 12.0
service timestamps debug uptime
service timestamps log uptime
no service password-encryption
!
hostname yertle
!
enable secret 5 $1$me5Q$2kF5zKlPPTvHEBdGiEZ9m/
enable password ww
!
ip subnet-zero
!
cns event-service server

!--- Configure the IKE policy and preshared key for the hub:

crypto isakmp policy 1
authentication pre-share
crypto isakmp key cisco170 address 150.150.150.1 

!--- Configure the IPSec parameters: !--- IPSec transform set.

crypto ipsec transform-set 170cisco esp-des esp-md5-hmac

!--- Crypto map definition for the hub site.

crypto map ETH0 17 ipsec-isakmp 

!--- Set the peer.
 
set peer 150.150.150.1

!--- IPSec transform set.

set transform-set 170cisco

!--- Interesting traffic for peer 150.150.150.1 (hub site).
 
match address 170
!
interface Ethernet0
ip address 150.150.150.2 255.255.255.0
no ip directed-broadcast
no ip route-cache
no ip mroute-cache
no mop enabled

!--- Apply crypto map on the interface.

crypto map ETH0
!
interface Serial0
no ip address
no ip directed-broadcast
no ip mroute-cache
shutdown
no fair-queue
!
interface Serial1
ip address 170.170.170.1 255.255.255.0
no ip directed-broadcast
!
ip classless
ip route 160.160.160.0 255.255.255.0 150.150.150.1
no ip http server

!--- Access list that shows traffic to encryption for !--- the hub site (dr_whoovie).

access-list 170 permit ip 170.170.170.0 0.0.0.255 160.160.160.0 0.0.0.255
dialer-list 1 protocol ip permit
dialer-list 1 protocol ipx permit
!
tftp-server flash:/c2500-jos56i-l.120-7.T
tftp-server flash:c2500-jos56i-l.120-7.T
tftp-server flash:
!
line con 0
transport input none
line aux 0
line vty 0 4
password ww
login
!
end