Document ID: 10700
Contents
Introduction
Prerequisites
Requirements
Components Used
Conventions
Configure
Network Diagram
Configurations
Verify
Troubleshoot
NetPro Discussion Forums - Featured Conversations
Related Information
Introduction
This document provides a sample configuration for VINES over ISDN.
Prerequisites
Requirements
There are no specific requirements for this document.
Components Used
This document is not restricted to specific software and hardware versions.
Conventions
Refer to Cisco Technical Tips Conventions for more information on document conventions.
Configure
In this section, you are presented with the information to configure the features described in this document.
Note: Use the Command Lookup Tool ( registered customers only) to find more information on the commands used in this document.
Network Diagram
This document uses this network setup:
Configurations
This document uses these configurations:
|
Router A |
|---|
hostname RouterA username RouterB password 7 A1B2C3D4E5F6G7 vines routing 3009AE57:0001 isdn switch-type basic-net3 interface Ethernet0 ip address 198.92.60.135 255.255.255.0 vines metric 2 no mop enabled interface BRI0 no ip address encapsulation ppp vines metric 10 vines neighbor 3011B50E:0001 10 dialer map vines 3011B50E:0001 name RouterB broadcast 208 dialer hold-queue 10 dialer-group 1 ppp authentication chap vines route 002C501E 3011B50E:0001 50 vines access-list 100 deny RTP 00000000:0000 FFFFFFFF:FFFF 00000000:0000 FFFFFFFF:FFFF vines access-list 100 permit IP 00000000:0000 FFFFFFFF:FFFF 00000000:0000 FFFFFFFF:FFFF dialer-list 1 protocol vines list 100 |
|
Router B |
|---|
hostname RouterB username RouterA password 7 A1B2C3D4E5F6G7 vines routing 3011B50E:0001 isdn switch-type basic-net3 interface Ethernet0 ip address 198.92.60.116 255.255.255.0 vines metric 2 no mop enabled interface BRI0 no ip address encapsulation ppp vines metric 10 vines neighbor 3009AE57:0001 10 dialer map vines 3009AE57:0001 name RouterA broadcast 203 dialer hold-queue 10 dialer-group 1 ppp authentication chap vines access-list 100 deny RTP 00000000:0000 FFFFFFFF:FFFF 00000000:0000 FFFFFFFF:FFFF vines access-list 100 permit IP 00000000:0000 FFFFFFFF:FFFF 00000000:0000 FFFFFFFF:FFFF dialer-list 1 protocol vines list 100 |
This configuration allows VINES traffic to trigger a dial-out on the ISDN link.
Note: Router B supports a serverless client.
Verify
There is currently no verification procedure available for this configuration.
Troubleshoot
There is currently no specific troubleshooting information available for this configuration.
NetPro Discussion Forums - Featured Conversations
| NetPro Discussion Forums - Featured Conversations for LAN |
| Network Infrastructure: LAN Routing and Switching |
| Network Infrastructure: Getting Started with LANs |
Related Information
| Updated: Oct 04, 2005 | Document ID: 10700 |
