Cisco BSTUN/BSC/Bisync Hardware Support Levels [IP Tunneling]

Document ID: 55518

Introduction
Prerequisites
      Requirements
      Components Used
      Conventions
Hardware Support Table
NetPro Discussion Forums - Featured Conversations
Related Information

Introduction

This document provides the sets of platforms, interfaces, and related Cisco IOS® Software Releases that support Block Serial Tunnel (BSTUN), binary synchronous communication (BSC), and Binary Synchronous Communication Protocol (Bisync).

Prerequisites

Requirements

There are no specific requirements for this document.

Components Used

This document is not restricted to specific software and hardware versions.

Conventions

For more information on document conventions, refer to the Cisco Technical Tips Conventions.

Hardware Support Table

Cisco Platform	Interface (if applicable)	Cisco IOS Software Support
1720		12.0(2)T
2500		10.3
2600	WIC-1T WIC-2T WIC-2AS NM-4AS NM-8AS	11.3(2)XA 11.3(3)T
3600		11.1(7)AA 11.2(5)P
3810		12.0.2aT1
4000 4500 4700	NP4T	10.3
4000 4500 4700	NP-2T16S-RS232 NP-2T16S-V.35	11.2(3)P
7200	PA-4T+ PA-8T	11.2(7)P
1600		11.2(6.4)P

Note: The PA-4T does not support BSC; you must have a PA-4T+. There is no upgrade path from the PA-4T to the PA-4T+.

NetPro Discussion Forums - Featured Conversations

Networking Professionals Connection is a forum for networking professionals to share questions, suggestions, and information about networking solutions, products, and technologies. The featured links are some of the most recent conversations available in this technology.

NetPro Discussion Forums - Featured Conversations for IBM

Network Infrastructure: Enterprise Data Centers

Related Information

Updated: Nov 12, 2006

Document ID: 55518

Hierarchical Navigation

IP Tunneling