IBM SNA Networking

Document ID: 12287

Contents

Introduction
Prerequisites
      Requirements
      Components Used
      Conventions
Configure
      Network Diagram
      Configurations
Verify
Troubleshoot
NetPro Discussion Forums - Featured Conversations
Related Information

Introduction

This document provides a sample for the configuration of QLLC to SDLC direct.

Prerequisites

Requirements

There are no specific requirements for this document.

Components Used

This document is not restricted to specific software and hardware versions.

Conventions

Refer to Cisco Technical Tips Conventions for more information on document conventions.

Configure

Note: Use the Command Lookup Tool ( registered customers only) to find more information on the commands used in this document.

Network Diagram

This document uses this network setup:

Configurations

This document uses these configurations:

interface serial 0 
encapsulation x25 
x25 address 200 
x25 ltc 5 
x25 htc 16 
x25 map qllc 4000.2500.00c1 201 
qllc xid 4000.2500.00c1 017F3E59 

interface serial 1 
no ip address 
encapsulation sdlc-primary 
no keepalive 
sdlc address c1 
sdlc qllc-prtnr 4000.2500.00c1 c1 
no sdlc slow-poll

Note: This works for a PU 2.0-only SDLC device. A clock rate setting is needed on serial 1 if the interface acts as DCE. In addition, the duplex and encoding setting must match the setting on the controller.

Verify

There is currently no verification procedure available for this configuration.

The Output Interpreter Tool ( registered customers only) (OIT) supports certain show commands. Use the OIT to view an analysis of show command output.

Troubleshoot

There is currently no specific troubleshooting information available for this configuration.

NetPro Discussion Forums - Featured Conversations

Related Information

• Product Support
• Technology Support
• Technical Support & Documentation - Cisco Systems