With Cisco Unified Intelligence Center (CUIC) 8.5(3), the Agent Not Ready Detail report shows no data in CUIC reporting and this document discusses how to troubleshoot this issue.
There are no specific requirements for this document.
The information in this document is based on the Cisco Unified Intelligence Center (CUIC) 8.5(3).
The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, make sure that you understand the potential impact of any command.
Refer to Cisco Technical Tips Conventions for more information on document conventions.
With Cisco Unified Intelligence Center (CUIC) 8.5(3), the Agent Not Ready Detail report shows no data in CUIC reporting. The Agent Not Ready Detail report defaults to the Real-Time database in the standard report and this report is dependent on Historical data. This works fine in scenarios where the HDS and AW or Real-Time and historical database are on the same server. But, in large deployments where they may be on different servers that the realtime views of the historical data will not work. So if you use a large deployment model where the real time data is separated, they are pointed to a AWDB that has no HDS to reference.
As a workaround, complete these steps:
Export the report definition. Choose Report Definitions > Select > Export.
Delete the report and report the definition from CUIC.
Re-import the exported report definition back. ChooseReport Definitions > Import and choose the exported definition. Choose the Historical Data Source during import.
This would allow you to run the stock report against the historical database.
The Cisco Support Community is a forum for you to ask and answer questions, share suggestions, and collaborate with your peers.
Refer to Cisco Technical Tips Conventions for information on conventions used in this document.