Cisco Nexus 6000 Series NX-OS Unicast Routing Command Reference

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Book Contents

Preface
- A Commands
- B Commands
- C Commands
- E Commands
- F Commands
- H Commands
- I Commands
- L Commands
- M Commands
- N Commands
- P Commands
- R Commands
- S Commands
- Show Commands
- T Commands
- V Commands
- A Commands
- C Commands
- D Commands
- E Commands
- F Commands
- I Commands
- L Commands
- M Commands
- R Commands
- S Commands
- Show Commands
- T Commands
- A Commands
- C Commands
- D Commands
- F Commands
- H Commands
- I Commands
- L Commands
- M Commands
- P Commands
- R Commands
- S Commands
- Show Commands
- T Commands
- V Commands

Find Matches in This Book

Results

Updated:: December 22, 2011

T Commands

This chapter describes the Cisco NX-OS unicast Routing Information Base (RIB) and the Forwarding Information Base (FIB) commands that begin with T.

test forwarding distribution perf

To test the forwarding distribution performance of the Forwarding Information Base (FIB), use the test forwarding distribution perf command.

test forwarding distribution perf

Syntax Description

This command has no arguments or keywords.

Command Default

None

Command Modes

Command HistoryAny command mode


Release	Modification
5.0(3)N1(1)	This command was introduced.

Examples

This example shows how to test the forwarding distribution performance:

switch# test forwarding distribution perf

Related Commands


Command	Description
show forwarding distribution	Displays information about the FIB.

test forwarding inconsistency

To trigger the Layer 3 inconsistency checker for the Forwarding Information Base (FIB), use the test forwarding inconsistency command.

test forwarding inconsistency [ip | ipv4] [unicast] [vrf vrf-name] [module {slot | all}] [stop]

Syntax Description


ip	(Optional) Specifies the inconsistency check for IPv4 routes.
ipv4	(Optional) Specifies the inconsistency check for IPv4 routes.
unicast	(Optional) Specifies the inconsistency check for unicast routes.
vrf vrf-name	(Optional) Specifies the virtual routing and forwarding (VRF) context name. The name can be any case-sensitive, alphanumeric string up to 32 characters.
module	(Optional) Specifies the inconsistency check for one or more modules.
slot	Module number. The range depends on the platform.
all	(Optional) Specifies the inconsistency check for all modules.
stop	(Optional) Stops the inconsistency check.

Command Default

None

Command Modes

Command HistoryAny command mode


Release	Modification
5.0(3)N1(1)	This command was introduced.

Examples

This example shows how to trigger the Layer 3 inconsistency checker for all modules:

switch# test forwarding inconsistency module all

This example shows how to stop the Layer 3 inconsistency checker for all modules:

switch# test forwarding inconsistency module all stop

Related Commands


Command	Description
clear forwarding inconsistency	Clears the FIB inconsistencies.
show forwarding inconsistency	Displays information about the FIB inconsistencies.

Was this Document Helpful?

Feedback

Contact Cisco

Open a Support Case
(Requires a Cisco Service Contract)