The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
This chapter describes the Cisco NX-OS Enhanced Interior Gateway Routing Protocol (EIGRP) commands that begin with F.
To enable the Enhanced Interior Gateway Protocol (EIGRP), use the feature eigrp command. To disable EIGRP, use the no form of this command.
feature eigrp
no feature eigrp
This command has no arguments or keywords.
Disabled
Global configuration mode
|
|
---|---|
6.0(2)N1(1) |
This command was introduced. |
You must enable the EIGRP feature before you can configure EIGRP.
This command requires the LAN Base Services license.
This example shows how to enable the EIGRP feature:
switch# configure terminal
switch(config)# feature eigrp
switch(config)#
This example shows how to disable the EIGRP feature:
switch# configure terminal
switch(config)# no feature eigrp
switch(config)#
|
|
---|---|
router eigrp |
Creates a EIGRP instance. |
show feature |
Displays the features enabled on the switch. |
show ip eigrp |
Displays EIGRP configuration information. |
To flush all EIGRP routes in the unicast RIB when an EIGRP instance restarts, use the flush-routes command. To disable this feature, use the no form of this command.
flush-routes
no flush-routes
This command has no arguments or keywords.
Disabled
Router configuration mode
|
|
---|---|
6.0(2)N1(1) |
This command was introduced. |
This command requires the LAN Base Services license.
This example shows how to flush routes when an EIGRP instance restarts:
switch(config)# router eigrp Test1
switch(config-router)# flush-routes
switch(config-router)#
|
|
---|---|
show ip eigrp interfaces |
Displays information about EIGRP interfaces. |