DHCP Server
|
Choose the DHCP server name from the drop-down list box.
|
Subnet IPv4 Address
|
Enter the Subnet IPv4 address.
|
Primary Start IPv4 Address
|
Enter the start IPv4 address of the first range of IP addresses to be assigned.
|
Primary End IPv4 Address
|
Enter the end IPv4 address of the first range of IP addresses to be assigned.
|
Secondary Start IPv4 Address
|
Enter the start IPv4 address of the second range of IP addresses to be assigned.
|
Secondary End IPv4 Address
|
Enter the end IPv4 address of the second range of IP addresses to be assigned.
|
Primary Router IPv4 Address
|
Enter the IPv4 address of the primary router on your subnet.
|
Secondary Router IPv4 Address
|
Enter the IPv4 address of the secondary router on your subnet.
|
IPv4 Subnet Mask
|
Enter the subnet mask.
|
Domain Name
|
This field specifies the name that you should use when resolving hostname via the Domain Name System.
|
Primary DNS IPv4 Address
|
This field specifies primary DNS IPv4 server name.
|
Secondary DNS IPv4 Address
|
This field specifies secondary DNS IPv4 server name.
|
TFTP Server Name (Option 66)
|
Use this field to identify a TFTP server. You can configure only one DNS name or a dotted decimal IP address in this parameter.
|
Primary TFTP Server IPv4 Address (Option 150)
|
This field specifies the IPv4 addresses for primary Trivial File Transfer Protocol (TFTP) server.
|
Secondary TFTP Server IPv4 Address (Option 150)
|
This field specifies the IPv4 addresses for secondary TFTP server.
|
Bootstrap Server IPv4 Address
|
This field specifies the address of the server that is used in the next step of the bootstrap process. You can use this as
the IPv4 address of the TFTP server or as the default value to DHCP server address if the server is to supply the next bootstrap
service.
|
ARP Cache Timeout (sec)
|
This field specifies the timeout in seconds for ARP cache entries. Specify the time as a 32-bit unsigned integer.
|
IP Address Lease Time (sec)
|
The DHCP server uses the information in this field to specify the lease time that it is willing to offer. Specify the time
in units of seconds and as a 32-bit unsigned integer.
|
Renewal (T1) Time (sec)
|
This field specifies the time interval from address assignment until the client transitions to the RENEWING state.
|
Rebinding (T2) Time (sec)
|
This field specifies the time interval from address assignment until the client transitions to the REBINDING state. Specify
the value in units of seconds and as a 32-bit unsigned integer.
|