Usage Guidelines for DSCP Marking
To configure DSCP marking:
-
Use CLI commands to set DSCP values for N2/SCTP and N26/GTPC interfaces.
-
DSCP values can be configured as hexadecimal (e.g.,
0x0-0x3F
) or decimal (range:0-63
). -
If DSCP value is not specified in the configuration then the default DSCP value is set to 0.
-
Configured values apply to all outgoing requests and responses on the specified interface.
-
DSCP marking is configured per interface, not per peer or session.
-
Supports runtime changes to DSCP values.