ラインカード構成の移行

この章では、ラインカードを交換したときにラインカードの構成を移行する方法について説明します。

交換時にラインカード構成を別のラインカードに移行する

別のラインカードを交換しながら、ラインカードの構成を移行できます。これにより、ラインカードの構成が失われることはありません。


Note


  • ライン カードが同じスイッチング モジュールであることを確認します。たとえば、古い 48 ポート ラインカードを別の新しい 48 ポート ラインカードにのみ交換します。

  • 移行される構成の一部は、ポートの VSAN、ポートの説明、バッファクレジット、ポート速度などです。


Procedure


Step 1

switch# migrate configuration linecard module

有効なラインカード モジュールを表示します
migrate configuration linecard 

Valid modules are as shown below
+-----+-------+-------------------------------------+----------------+--------+
| Mod | Ports | Module-Type                         | Model          | Status |
+-----+-------+-------------------------------------+----------------+--------+
| 1   | 48    | 2/4/8/10/16 Gbps Advanced FC Module | DS-X9448-768K9 | ok     |
| 5   | 48    | 2/4/8/10/16 Gbps Advanced FC Module | DS-X9448-768K9 | ok     |
+-----+-------+-------------------------------------+----------------+--------+

Step 2

移行または交換したラインカードのモジュール番号を入力し、Enter を押します。


Enter module number which needs to be migrated/replaced: 1

Collecting configuration details of module 1 (DS-X9448-768K9). Please wait...

Successfully collected the configuration details of module 1 (DS-X9448-768K9) in file bootflash:module_config.cfg.

Step 3

スイッチング モジュールを取り外して新しいスイッチング モジュールと交換し、Enter を押します。

Remove module 1 (DS-X9448-768K9) , replace it with the new module and press enter 

Step 4

y と入力して新しいスイッチング モジュールの交換を確認し、Enter を押します。

Have you inserted the new module in slot 1? (y/n): y

Booting up the new module in slot 1 . Please wait...

The new module in slot 1 (DS-X9648-1536K9) is up.
Applying the configs to the new module. Please wait..

Successfully applied the config bootflash:module_config.cfg to running config.

Elapsed time: 0 hours, 3 minutes, 55 seconds