Browser Support
For supported browsers, see Solution Compatibility Matrix.
The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
For supported browsers, see Solution Compatibility Matrix.
When you complete the AppAdmin inital setup, the end user with administrator capability as configured in AppAdmin web interface can login to Cisco VVB Serviceability. You can also log in as an Application user with default administrator capability configured during the installation of Cisco VVB. See the Cisco Virtualized Voice Browser Installation Guide and Cisco Unified CVP Configuration Guide for detailed instructions on initial AppAdmin setup and how to assign administrator capability to end users.
Note |
Cisco VVB does not support clustering. Therefore, you may ignore any message on the Cisco VVB Admin UI/CLI that refers to cluster, publisher, subscriber, etc. |
To access Cisco VVB Serviceability:
Step 1 |
By using a supported web browser, open a browser session. |
||
Step 2 |
From the VVB Administration page click the Navigation drop down and select Cisco VVB Serviceablity then Go. |
||
Step 3 |
Enter an applicable username and password, and click Login.
|
In addition to troubleshooting, configuring logging and tracing, and doing service-related tasks in Cisco VVB Serviceability, you can do the following tasks:
To display documentation for a single window, click
.To verify the version of Cisco VVB Serviceability running on the server, click or click the About link in the upper-right corner of the window.
To go directly to the home page in Cisco VVB Serviceability from a configuration window, click Cisco VVB Serviceability from the Navigation drop-down box.
To access Cisco VVB Administration or other applications, click the applicable application from the Navigation drop-down box and click Go.
To log out of Cisco VVB Serviceability, click the Logout link in the upper-right corner of the window.
On each Cisco VVB Serviceability configuration page, configuration icons appear that correspond to the configuration buttons at the bottom of the page. (For example, you can click either the Save icon or the Save button to complete the task.)