Cisco Host Upgrade Utility 2.0(1) User Guide

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Book Contents

Find Matches in This Book

Results

Updated:: March 4, 2015

Chapter: Troubleshooting

Troubleshooting

Troubleshooting

This chapter contains the following topics:

Troubleshooting

Troubleshooting

The following table describes troubleshooting suggestions for issues that you might encounter.

Issue	Suggested Solution
Connection to Cisco IMC is lost after an update and reboot and the KVM session ends.	This is expected behavior after a firmware update. Log back in to the Cisco IMC and reestablish your KVM session.
The following error message is observed: `PID, Board Part Number, Product Part Number <PID, Board Part Number, Product Part Number> is not supported by this HUU image. HUU will not boot on this machine. Press any key to reboot the server.`	This error message is displayed when the HUU ISO is not supported by the server. Use the HUU ISO that is supported by the server.

Was this Document Helpful?

Feedback

Contact Cisco

Open a Support Case
(Requires a Cisco Service Contract)