Unsupported Features
Information about the unsupported features is recorded in the platform release notes.
The following link provides a reference to the unsupported feature section in the release notes:
- Preface
- Configuring Multiprotocol Label Switching (MPLS)
- Configuring eBGP and iBGP Multipath
- Configuring EIGRP MPLS VPN PE-CE Site of Origin
- Configuring Ethernet-over-MPLS and Pseudowire Redundancy
- Configuring IPv6 Provider Edge over MPLS (6PE)
- Configuring IPv6 VPN Provider Edge over MPLS (6VPE)
- Configuring MPLS Layer 3 VPN
- Configuring MPLS VPN InterAS Options
- Configuring MPLS Layer 2 VPN over GRE
- Configuring MPLS Layer 3 VPN over GRE
- Configuring MPLS QoS
- Configuring MPLS Static Labels
- Configuring MPLS Traffic Engineering and Enhancements
- Configuring Any Transport over MPLS: Tunnel Selection
- Configuring MPLS Traffic Engineering—Bundled Interface Support
- Configuring MPLS Traffic Engineering Forwarding Adjacency
- Configuring MPLS Traffic Engineering (TE)—IP Explicit Address Exclusion
- Configuring MPLS Traffic Engineering—LSP Attributes
- Configuring MPLS Traffic Engineering—Configurable Path Calculation Metric for Tunnels
- Configuring MPLS Traffic Engineering—RSVP Graceful Restart
- Configuring MPLS Traffic Engineering—Verbatim Path Support
- Configuring Virtual Private LAN Service (VPLS) and VPLS BGP-Based Autodiscovery
- Configuring Hierarchical VPLS with MPLS Access
- Configuring VPLS: Routed Pseudowire IRB for IPv4 Unicast
- Configuring VPLS MAC Address Withdrawal
- Configuring MPLS VPN Route Target Rewrite
- Configuring MPLS VPN-Inter-AS-IPv4 BGP Label Distribution
- Configuring Seamless MPLS
- Troubleshooting Multiprotocol Label Switching
- Unsupported Features
Feedback