Cisco Nexus 9000 Series NX-OS Multicast Routing Configuration Guide, Release 6.x

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Book Contents

Find Matches in This Book

Results

Updated:: September 23, 2014

New and Changed Information

This chapter provides release-specific information for each new and changed feature in the Cisco Nexus 9000 Series NX-OS Multicast Routing Configuration Guide, Release 6.x.

New and Changed Information

This table summarizes the new and changed features for the Cisco Nexus 9000 Series NX-OS Multicast Routing Configuration Guide, Release 6.x and tells you where they are documented.

Table 1. New and Changed Features for Cisco NX-OS Release 6.x
Feature	Description	Changed in Release	Where Documented
PIM	Added the ability to delay participation in the designated router election, upon bootup or following an IP address or interface state change.	6.1(2)I3(2)	Configuring PIM
IGMP snooping	Added the ability to filter IGMP snooping reports.	6.1(2)I2(2)	Configuring IGMP Snooping
IGMP	Added support for Layer 2 switching.	6.1(2)I2(1)	Configuring IGMP
IGMP snooping	Introduced this feature.	6.1(2)I2(1)	Configuring IGMP Snooping
PIM	Added vPC support for PIM ASM.	6.1(2)I2(1)	Configuring PIM

Was this Document Helpful?

Feedback

Contact Cisco

Open a Support Case
(Requires a Cisco Service Contract)